IBM eServer 130 xSeries, Руководство пользователя

Страница: 80 / 156

66
IBM xSeries 130: User’s Reference
1. Review the information in “Safety” on page vii.
2. Turn off the appliance server and disconnect all external cables and power cords.
3. Remove the cover according to “Removing the cover” on page 56.
4. Remove the plastic shield from the server.
5. Lift up the microprocessor release lever and remove the terminator card from the
microprocessor connector.
6. Install the microprocessor in the microprocessor connector.
Attention: To avoid bending the pins, do not use excessive force.
7. Push the release lever down to lock the microprocessor into place.
8. Install the heat sink onto the microprocessor.
9. Replace the clear shield.
Note: The clear shield must be installed to maintain proper air flow and cooling
inside the server.
10. If you have other options to install, install them now. Otherwise, go to “Installing
the cover” on page 68.
Clip
Heatsink
Microprocessor
Terminator card
Heatsink release
lever
Slot
Top view of
heatsink