IBM eServer 130 xSeries, Руководство пользователя

Страница: 125 / 156

Chapter 7. Solving problems
111
Replacing the battery
When replacing the battery you must replace it with a lithium battery of the same type,
from the same manufacturer. To avoid possible danger, read and follow the safety
statement below.
To order replacement batteries, call 1-800-772-2227 within the United States, and 1-
800-465-7999 or 1-800-465-6666 within Canada. Outside the U.S. and Canada, call
your IBM reseller or IBM marketing representative.
Note: After you replace the battery, you must reconfigure your appliance server and
reset the system date and time.
Statement 2
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode
if not properly used, handled, or disposed of.
Do not:
• Throw or immerse into water
• Heat to more than 100
°
C (212
°
F)
• Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
Complete the following steps to replace the battery:
1. Read “Safety” on page vii, and follow any special handling and installation
instructions supplied with the replacement battery.
2. Turn off the appliance server and peripheral devices, and disconnect all external
cables and power cords; then, remove the appliance server cover.
3. Remove the battery:
a. Use one finger to lift the battery clip over the battery.
b. Use one finger to slightly slide the battery out from its socket. The spring
mechanism will push the battery out toward you as you slide it from the
socket.
c. Use your thumb and index finger to pull the battery from under the battery
clip.
d. Ensure that the battery clip is touching the base of the battery socket by
pressing gently on the clip.