IBM Elastic Storage System 3200, Руководство по планированию и установке оборудования

Страница: 116 / 156

The steps to set an IP address for the enP1p8s0f0 device are as follows:
1. Log in as a root user.
2. Delete the
mgmt network.
# nmcli c del mgmt
3. Modify the IP address and the mask.
# nmcli con add type ethernet con-name enP1p8s0f0 ifname enP1p8s0f0 ipv4.addr
'192.168.20.21/24' ipv4.method manual
A sample output is as follows:
You can do the following steps to avoid this issue:
1. Do not run the Assign IP address to Management Interface (C11-T1) option on the p9 protocol node
and the p9 EMS node.
2. Set an IP address by issuing the following command:
# nmcli c del enP1p8s0f0 ; nmcli con add type ethernet con-name enP1p8s0f0 ifname
enP1p8s0f0 ipv4.addr '192.168.20.21/24' ipv4.method manual
3. Change the IP address and the mask.
4. Verify that a correct IP address is set by using the essutils tool.
5. Run the Check management interface (C11-T1) option and press c to change the
mgmt device to the
enP1p8s0f0 device.
6. Verify whether a correct IP is set.
/sbin/ifconfig enP1p8s0f0
Issues in the console redirection enablement using ipmitool
IBM SSRs must enable console redirection when logged into the BMC over serial.
If a canister is powered on and the password is not working, the ipmitool password could be incorrect.
1. Bring up the console by using a mini DVI cable. Contact ESS service for more information.
2. Log in to the O/S as a root user and reset the ipmi password.
ipmitool user set password 2 <new_bmc_pw>
The BMC password is the enclosure serial number.
3. Reconnect the serial cable and try to enable console redirection again.
98 IBM Elastic Storage System 3200: Hardware Planning and Installation Guide