IBM Brocade, Инструкция по установке и эксплуатации

Страница: 52 / 74

40 Brocade 2-Port 10GbE Converged Network Adapter for IBM BladeCenter Installation and User’s Guide
System-configuration problems
6
•
Make sure that you are using the correct expansion-card NVRAM settings for the storage area
network (SAN) and operating system.
System-configuration problems
To determine whether the installation problem is caused by the system configuration, perform the
following tasks:
•
Make sure that the I/O modules that support Ethernet or Fibre Channel operation are correctly
configured.
•
Make sure that the blade server is correctly configured.
•
Make sure that the BladeCenter unit and all other BladeCenter components are correctly
configured.
•
Make sure that all parameters, internal devices, and external devices have been enabled,
where required. These devices might include the I/O module and its internal and external
ports.
For additional information, see the documentation that comes with the management module
and the applicable utility programs and devices.
If you still have a system-configuration problem, you must determine whether the system board in
the blade server requires a special configuration. To determine whether the system board requires
a special configuration, see the documentation that comes with your BladeCenter unit and blade
server, or contact your IBM technical-support representative.
Note: For additional information about configuration requirements, see the documentation that
comes with your BladeCenter unit, blade server, and other BladeCenter components.
Ethernet device problems
To determine whether your problem is caused by an attached Ethernet device, perform the
following tasks.
•
Make sure that the adapter is not installed in an IBM BladeCenter Storage Expansion Unit 3.
The two 1GB Ethernet ports are not functional when the adapter is installed in this expansion
unit.
•
Make sure that an I/O module that supports Ethernet operation is correctly installed in bay 7
or bay 9 of a Multi-Switch Interconnect Module for IBM BladeCenter (MSIM).
NOTE
Note: Installing a second I/O module in the BladeCenter unit provides a backup I/O module in
case one I/O module fails. Both I/O modules must be of the same type, in the previously
specified I/O-module bay combinations in the BladeCenter unit.
•
Make sure that the blade server is turned on.