IBM Aptiva 2161, Руководство пользователя

Страница: 59 / 222

002 (continued)
3. Press F1 while the POST Configuration icon is displayed.
4. In the Setup Utility Main Menu, select Rapid Resume and press
Enter.
5. Write down the present setting of the
APM BIOS Mode
(top line of
screen) and press the
←
key, if needed, to select
Disable
in
the APM BIOS Mode field.
Note:
Disabling the APM BIOS Mode will disable Rapid Resume without
changing other customer APM settings.
6. Press Esc to exit the Rapid Resume menu.
7. Press Esc again to exit the screen.
8. Press Enter to save the changes and exit the Setup Utility.
9. Rapid Resume is now disabled.
When service is complete, restore the
APM BIOS Mode
to its original
setting.
1. Power-on the system unit.
2. Press F1 while the POST Configuration icon is displayed.
3. In the Setup Utility, select Rapid Resume and press Enter.
4. Press the
←
key, if needed, to select
Enable
in the APM BIOS
Mode field.
5. Press Esc to exit the Rapid Resume menu.
6. Press Esc again to exit the screen.
7. Press Enter to save the changes and exit the Setup Utility.
The system is now returned to the APM BIOS Mode customer
setting.
– Go to Step 005.
003
Insert the Diagnostics and Utilities CD in the CD-ROM drive.
DOES THE SYSTEM LOAD THE ADVANCED DIAGNOSTIC PROGRAM
FROM THE CD-ROM DRIVE WHEN POWERED OFF AND THEN ON?
Yes No
004
– Go to “Factory-Installed Drive Devices” on page 2-43.
005
(From step 002)
(Step 005 continues)
Check Procedures
2-5