IBM Aptiva 2161, Руководство пользователя

Страница: 172 / 222

Hard Disk Drive Jumper Settings
Up to four drive devices (hard disk, CD-ROM, or Zip drives) can be installed
in the Type 2161 Service Level A systems. If any drives do not show in the
Installed Devices list in the Setup Utility, ensure the jumper settings and
connectors are set as shown here. Refer to “System Board Layout” on
page 5-2 for connector location information.
Primary Hard Disk Drive IDE Local Bus Connector
At the primary hard disk drive IDE connector, make sure the first drive
installed is set as the master drive (
.1/
in the following figures).
Note: If a second drive is installed in the primary hard disk drive IDE
connector, set the jumpers as the slave drive (
.2/
in the following
figures).
All recovery preloaded software should be installed on the master hard disk
drive on the primary connector.
Secondary Hard Disk Drive Connector
If additional drives are connected to the secondary hard disk drive
connector, set the first drive connected to this connector as the master drive
(
.1/
in the following figures). If a second drive is connected to the
secondary hard disk drive connector, set the jumpers as the slave drive (
.2/
in the following figures). Ensure all software is set to recognize all installed
drives.
The CD-ROM drive is connected to the secondary drive connector at the
factory as the master drive. If an additional hard disk drive is connected to
the secondary connector, it must be set as the master drive,
.1/
, and the
CD-ROM drive jumpers reset as the slave drive (see “CD-ROM Drive
Jumper Settings” on page 5-13).
Note: Check the Setup Utility for correct installation:
Hard Disk 1 Master drive
Hard Disk 2 Slave drive (Zip drive with internal Zip drive models)
Hard Disk 3 Master drive (CD-ROM if other drive not connected to this
connector)
Hard Disk 4 Slave drive (CD-ROM if hard disk or internal Zip drive
installed at secondary connector, Hard Disk 3)
5-10
Machine Type 2161 - Service Level A Aptiva HMS