IBM Aptiva 2161, Руководство пользователя

Страница: 158 / 222

Note
Dim control is for incandescent lighting only. Dim control must not be
used for fluorescent lighting or for appliances.
Home Director Troubleshooting
Refer to the Home Director On-line help information and troubleshooting
aids.
Things to Check:
Ÿ
Make sure the Serial Interface Module is plugged into a working outlet.
If the outlet is controlled by a switch, make sure the switch is on.
Ÿ
Do not connect the Serial Interface Module into a surge protector. The
surge protector will block signals from the computer to the power lines.
Ÿ
Make sure the House Code is set correctly in the Home Director
software and that the physical modules address code is set.
Ÿ
Make sure the Serial interface is configured to the correct COM port.
Ÿ
Make sure the module you are trying to control is fully plugged into the
wall outlet and that the switch for the appliance or light you are trying to
control is in the on position and it works when directly plugged into a
working wall outlet.
Ÿ
Make sure the device module is not plugged into a surge protector.
Ÿ
Power line noise can cause solid or intermittent failures.
Check these and similar items to see if they are operating when the
problem occurs:
– Baby monitors that transmit over the power line
– Blenders
– Electric carving knives
– Electric hair dryers
– Electric motors
– Electric shavers
– Floor scrubbers
– Food processors
– Laser printers
– Mixers
– Vacuum cleaners
– Wireless doorbells that use the power line
– Wireless intercoms in transmit (talk) mode
If the COM port tests correctly and you can not control any modules,
unplug the Serial Interface module from the wall outlet for about ten
4-20
Machine Type 2161 - Service Level A Aptiva HMS