IBM 8852 - BladeCenter H Rack-mountable, Инструкция по установке и эксплуатации

Страница: 35 / 82

v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the BladeCenter unit or rack for at least 2 seconds. This drains
static electricity from the package and from your body.
v Remove the device from its package and install it immediately without setting
down. If it is necessary to set down the device, put it back into its
static-protective package.
v Take additional care when handling devices during cold weather. Heating reduces
indoor humidity and increases static electricity.
Removing components before rack installation
Attention: See the BladeCenter H Problem Determination and Service Guide for
removing components from the BladeCenter unit when the unit is connected to
power.
Use the following procedures to remove components from the BladeCenter unit
before you install it in a rack and connect to power.
Removing a power module
To remove a power module, complete the following steps.
Release buttons
Release buttons
1. Read the safety information that begins on page v and “Installation guidelines”
on page 18.
2. Press the blue release button on each end of the bezel.
3. Pull the bezel away from the BladeCenter unit.
Chapter 3. Installing the BladeCenter unit and options
19