IBM 8852 - BladeCenter H Rack-mountable, Инструкция по установке и эксплуатации

Страница: 37 / 82

Removing a blade server
Attention: Note the bay number. Reinstalling a blade server into a different bay
than the one from which it was removed could have unintended consequences.
Some configuration information and update options are established according to
bay number.
To remove a blade server, complete the following steps.
Release handles
(open)
1. Read the safety information that begins on page v and “Installation guidelines”
on page 18.
2. Move the two release handles to the open position. The blade server moves out
of the bay approximately 0.6 cm (0.25 inch).
3. Pull the blade server out of the bay.
Removing a management module
To remove a management module or filler, complete the following steps.
Management
module
Release handle
(open)
Module
filler
1. Read the safety information that begins on page v and “Installation guidelines”
on page 18.
2. Pull the module release handle to the open position. The module moves out of
the bay approximately 0.6 cm (0.25 inch).
3. Slide the module out of the bay.
Chapter 3. Installing the BladeCenter unit and options
21