IBM 884015U, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 91 / 176

Note: See “System” on page 108 to determine which components a field service technician should replace.
Error code/symptom FRU/action
1600
(The system management processor is not
functioning) Before replacing a FRU,
remove the ac power to the server, wait 20
seconds; then, reconnect the ac power.
Wait 30 seconds; then, turn on the server.
System board
1601
(The system is able to communicate to the
system management processor, but the
system management processor failed to
respond at the start of POST.) Complete
the following steps before replacing a
FRU:
1. Remove the ac power to the server,
wait 20 seconds; then, reconnect the
ac power. Wait 30 seconds; then, turn
on the server.
2. Flash update the system management
processor.
1. Remote Supervisor Adapter, if installed
2. System board
1602
(Optional service processor not properly
installed.)
Disconnect all server and option power cords from server, wait 30
seconds, reconnect, and retry.
1762
(Hard disk configuration error)
1. Hard disk drive.
2. Hard disk cables.
3. Run the Configuration/Setup Utility program.
4. Hard disk adapter.
5. SCSI backplane.
6. System board.
178X
(Fixed disk error)
1. Hard disk cables.
2. Run diagnostics.
3. Hard disk adapter.
4. Hard disk drive.
5. System board.
1800
(No more hardware interrupt available for
PCI adapter)
1. Run the Configuration/Setup Utility program.
2. Failing adapter.
3. System board.
1962
(Drive does not contain a valid boot
sector)
1. Verify that a startable operating system is installed.
2. Run diagnostics.
3. Hard disk drive.
4. SCSI backplane.
5. Cable.
6. System board.
2400
(Video controller test failure)
1. Video adapter (if installed)
2. System board
2462
(Video memory configuration error)
1. Video adapter (if installed)
2. System board
Chapter 6. Symptom-to-FRU index
81