IBM 884015U, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 28 / 176

Working with adapters
The following notes describe the types of adapters that the server supports and
other information that you must consider when installing adapters:
Before you install an adapter, review the following information:
v
Locate the documentation that comes with the adapter and follow those
instructions in addition to the instructions in this section. If you need to change
the switch or jumper settings on the adapter, follow the instructions that come
with the adapter.
v
You can install only low-profile adapters in slots 1 and 2 on the PCI low-profile
card.
v You can install standard full-length adapters in slots 3 and 4 on the PCI riser
card.
v
Your server supports only 3.3 V and universal PCI adapters.
v
The PCI bus configuration is as follows:
– Non-hot-plug, 64-bit PCI-X slots 1 through 2 (PCI bus A, 100 MHz)
– Non-hot-plug, 64-bit PCI-X slot 3 (PCI bus B, 133 MHz)
– Non-hot-plug, 64-bit PCI-X slot 4 (PCI bus C, 133 MHz)
v The system scans devices in the following order, if you have not changed the
default boot precedence: integrated Ethernet controllers, integrated SCSI
controller (SCSI channel B, then SCSI channel A), and then PCI and PCI-X slots
1, 2, 3, and 4.
v
The optional Remote Supervisor Adapter II SlimLine can be installed only in a
dedicated slot on the system board. For details about installing a Remote
Supervisor Adapter II SlimLine, see the documentation that comes with the
adapter. The following illustration shows how to install the Remote Supervisor
Adapter II SlimLine.
Remote Supervisor
Adapter II SlimLine
Connector
Latch bracket
Retainer bracket
Slip the free end of the card under the tab on the retainer bracket; then, press
the card in the connector and make sure that all tabs on the latch bracket secure
the card in place.
18
xSeries 346 Types 8840 and 1880: Hardware Maintenance Manual and Troubleshooting Guide