IBM 8669 - Eserver xSeries 342, Руководство по техническому обслуживанию аппаратной части

Страница: 82 / 156

Note: If you hot-replace the primary adapter while the Ethernet traffic is being
handled by the secondary Ethernet controller, the traffic does not
automatically switch back to the primary adapter when the primary adapter
comes back online. See “Configuring for failover”.
Configuring for failover: The failover feature currently is supported by Windows NT
Server and Novell IntraNetWare. The setup required for each operating system
follows.
Windows NT Server:
IBM offers hot-plug support for Windows NT Server Version 4.0. Failover can work
in conjunction with hot-plug support or independently. If you are not using hot-plug
support, go to “Windows NT Server failover setup” on page 73.
Windows NT Server hot-plug setup:
IBM Netfinity Hot Plug PCI for Windows NT Server 4.0 package is available for
download from the IBM Web site at:
http://www.ibm.com/pc/support
Enter the brand type of Server , click on Downloadable files and look for Hot Plug .
The IBM Netfinity Hot Plug PCI for Windows NT Server 4.0 package uses the Intel
Desktop Management Interface (DMI) to control hot-plug support for the Ethernet
controllers. The Ethernet controller in your computer is DMI compliant. Download
and install the following software in the order listed:
1. IBM Failover DMI Agent
2. IBM PCI Hot Plug Solution
3. IBM Netfinity 10/100 Fault Tolerant Adapter device drivers
Note: The order of installation is important. You must install the IBM Netfinity Hot
Plug for Windows NT.
Note: The order of installation is important. You must install the IBM Netfinity Hot
Plug for Windows NT Server 4.0 package before you install the IBM Netfinity
10/100 Fault Tolerant Adapter driver. If you install the adapter device driver
before the PCI Hot Plug Solution package, the adapter device driver will not
recognize the hot-plug code. This happens because the adapter device
driver only checks the NT registry for the Hot Plug package during
installation. If the PCI Hot Plug Solution package is added after the adapter
device driver is installed, the adapter must be removed and added again in
order for it to detect the PCI Hot-Plug Solution code.
To install the IBM Failover DMI Agent:
1. Download the DMI EXE file from the xSeries Support web page and extract the
files onto a diskette.
2. Insert the diskette into the diskette drive.
3. From the Start menu, select the Run option.
4. Type A:\SETUP.EXE in the Open box.
5. Click Ok . The setup wizard opens.
6. Follow the instructions that are given by the setup wizard until the program is
installed.
7. Restart the server.
72
Hardware Maintenance Manual: xSeries 342 Type 8669