IBM 8669 - Eserver xSeries 342, Руководство по техническому обслуживанию аппаратной части

Страница: 106 / 156

Error Code/Symptom FRU/Action
1600 (The System Management
Processor is not functioning) Do the
following before replacing a FRU:
1. Ensure that a jumper is not installed
on J45.
2. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
1. System Board
1601 (The system is able to communicate
to the System Management Processor, but
the System Management Processor failed
to respond at the start of POST.) Do the
following before replacing a FRU:
1. Remove the ac power to the system,
wait 20 seconds; then, re-connect the
ac power. Wait 30 seconds; then,
power-on the system.
2. Flash update the Service Processor.
1. Remote Supervisor Adapter, if installed
2. System Board
1762 (Fixed Disk Configuration error)
1. Fixed Disk Drive
2. Fixed Disk Cables
3. Run Configuration/Setup
4. Fixed Disk Adapter
5. SCSI Backplane
6. System Board
178X (Fixed Disk error)
1. Fixed Disk Cables
2. Run Diagnostics
3. Fixed Disk Adapter
4. Fixed Disk Drive
5. System Board
1800 (No more hardware interrupt
available for PCI adapter)
1. Run Configuration/Setup
2. Failing Adapter
3. System Board
1962 (Drive does not contain a valid boot
sector)
1. Verify a bootable operating system is installed.
2. Run Diagnostics
3. Hard Disk Drive
4. SCSI Backplane
5. Cable
6. System Board
2400 (Video controller test failure)
1. Video Adapter (if installed)
2. System Board
2462 (Video memory configuration error)
1. Video Adapter (if installed)
2. System Board
96
Hardware Maintenance Manual: xSeries 342 Type 8669