IBM 8649 - Eserver xSeries 225, Руководство по техническому обслуживанию и устранению неисправностей

Страница: 77 / 194

Replacing the side cover
If you removed the support bracket or bezel, reinstall it before you replace the side
cover. See “Removing and installing the support bracket” on page 38 and
“Replacing the bezel” on page 66.
Note: The rear adapter retaining bracket rests against the server side cover. You
might find it easier to lay the server on its side to replace the side cover.
Complete the following steps to replace the side cover:
1. Before installing the cover, check that all cables, adapters, and other
components are installed and seated correctly and that you have not left loose
tools or parts inside the server.
2. Place the bottom lip of the side cover over the bottom edge of the server
chassis.
3. Rotate the side cover to a vertical position, inserting the tabs at the top of the
side cover into the matching slots in the server chassis.
4. Slide the side cover forward until it locks in place. Press down on the
cover-release-latch button as you close the cover-release latch to lock the side
cover.
Key lock
Cover-release
latch
5. For hot-swap hard disk drive models, open the server door and hold the
hot-swap lock bar in the closed position, lock the side cover key lock, and close
the server door.
6. Reconnect the external cables and power cords to the server; then, connect the
power cords to electrical outlets.
7. Turn on the attached devices; then, turn on the server.
Updating your server configuration
When you start your server for the first time after you add or remove an internal
option or an external SCSI device, you might see a message telling you that the
configuration has changed. The Configuration/Setup Utility program automatically
Chapter 4. Installing options
67