IBM 8364 E series, Руководство пользователя, Страница: 32 / 150

Exchanging the memory
Complete the procedure, “Removing the logic unit to
install parts” on page 18 before performing the
following Dual Inline Memory Module (DIMM)
procedures.
1. To remove a DIMM from the logic unit, press the
two tabs
«B¬
located at each end of the DIMM
«A¬
out and down.
2. To install a DIMM into the logic unit, align the
notches on the bottom of the DIMM
«A¬
with the
notched areas on the memory socket.
3.
Press down firmly on the center of DIMM
«A¬
until the memory socket tabs
«B¬
flip up.
4. See “Reassembling the Network Station” on
page 18.
Exchanging the lithium battery
Read “Caution notices” on page viii, and see
“Removing the logic unit to install parts” on page 18
before continuing.
1. To remove the battery, place your thumb on the
battery
«C¬
and lift it up with your index finger.
2.
Dispose of the used battery according to your
local regulations.
3. Install the new battery into the battery socket
«D¬
,
with the
″
+
″
sign facing up.
4.
See “Reassembling the Network Station” on
page 18.
Note: If you receive an error message on your screen
after performing this procedure, See “Chapter 11.
Identifying problems with hardware that is
configured for NS Boot” on page 69, or “Chapter 13.
Identifying problems with hardware that is
configured for BIOS” on page 93.
See “Setting the date and time” on page 57, and
“Part 3. Configuring the Network Station” on page 37
to reconfigure the Network Station.
20
IBM Network Station