IBM 8364 E series, Руководство пользователя, Страница: 30 / 150

It is important that you understand all of the information that is presented in
“Safety notices” on page vii before performing any hardware-related
procedures on Network Station hardware.
Installing and removing parts
Removing the logic unit to install parts
Read Safety notices, and “Handling static-sensitive
devices” on page viii before continuing.
1. Turn off the power supply switch
«A¬
.
2. Disconnect all cables from the Network Station.
3. Hold the Network Station cover assembly, lift
latch
«B¬
, and pull the logic unit
«C¬
out.
4.
Carefully lay the logic unit down with the
internal components facing up. You are now
ready to perform the installation procedures
provided in this chapter.
Attention: Do not set the logic unit down on the
white power switch.
5. Complete the procedure, “Reassembling the
Network Station” when you are finished
installing components in the logic unit.
Reassembling the Network Station
Read Safety notices, and “Handling static-sensitive
devices” on page viii before continuing.
1.
To reassemble the Network Station, carefully slide
the logic unit
«C¬
into the cover assembly while
depressing the slide stop
«D¬
.
2. Slide the logic unit completely into the cover
assembly, until the latch
«B¬
is engaged.
18
IBM Network Station