IBM 8364 E series, Руководство пользователя, Страница: 117 / 150

Table 9. BIOS error messages table (continued)
Not applicable D1 Initialize the cache: Replace logic unit
Not applicable D2 Restore cache status: Replace logic
unit
Not applicable D3 Configure the cache: Replace logic
unit
Not applicable D4 Flush cache: Replace logic unit
Not applicable D5 Enable cache: Replace logic unit
Not applicable D6 Disable cache: Replace logic unit
Not applicable D7 Set up cache: Replace logic unit
Not applicable E1 Set up system for video: Replace logic
unit
Not applicable E2 Video BIOS too large: Replace logic
unit
Not applicable E3 Video BIOS too large: Replace logic
unit
Not applicable E5 System management failure: Replace
memory.
Not applicable F1 System management failure: Replace
memory.
Not applicable F2 SMI Waiting for Power Off: Replace
logic unit
Not applicable 40 pointing device interface failure:
Replace mouse
Configuration errors
The following table defines the possible configuration error messages that can
occur during the startup sequence of the Network Station. These errors appear
in the upper left corner of the screen during the startup sequence. Improper
configurations in the setup utility cause these errors. For more information
regarding the Network Station setup utility, see “Chapter 12. Startup sequence
of Network Stations configured for WorkSpace On-Demand” on page 91. The
Network Station displays error codes on the monitor when it encounters
configuration errors.
To solve configuration errors, you can enter the setup utility and reset all
configuration options to default values (see “Load default settings” on
page 63), or clear CMOS (see “Clearing the administrator password and
CMOS, creating a recovery CompactFlash card, and reading a CompactFlash
Chapter 13. Identifying problems with hardware that is configured for BIOS
105