IBM 8239 Token-Ring Stackable Hub, Руководство по установке и эксплуатации

Страница: 44 / 141

Task Action
Remove an external device and its
ports from the stack data ring Type wrap ring_io both 1 and press Enter.
Insert an external device and its ports
into the stack data ring Type unwrap ring_io both 1 and press
Enter.
Remove hub 2 from the stack data
ring Type wrap data_io both 2 and press Enter.
Insert hub 2 into the stack data ring Type unwrap data_io both 2 and press
Enter.
Set up IP on hub 1 Type set ip 1 and press Enter.
When prompted, enter the following
information, pressing Enter after each value:
IP address: Type 9.197.4.67
Subnet mask: Type 255.255.255.0
Default gateway: Type 9.197.4.1
Get status for the stack Type display stack and press Enter.
Get status for hub 2 Type display hub 2 and press Enter.
Get status for port 4 on hub 2 Type display port 2.4 and press Enter.
Enable all ports on hub 1 Type enable port 1.all and press Enter.
Disable port 4 on hub 2 Type disable port 2.4 and press Enter.
Verifying, Saving, and Restoring Parameters
Verifying Parameters
To verify parameters that you have entered, type the appropriate DISPLAY
command.
Saving Parameters
If you change configuration settings and then the 8239 Model 1 loses power or is
reset before you save the changes, the changes are lost; the last-saved
configuration settings are used. For this reason, you should save configuration
information frequently.
To save the current configuration for all the 8239s in the stack, type save and
press Enter.
Restoring Parameters
To restore the last-saved configuration for all hubs in the stack, reset the 8239
without saving the configuration.
Configuring the 8239
This section explains how to configure the 8239 for:
¹
Out-of-band connectivity
¹
In-band connectivity
¹
Network monitoring
See “Configuration Parameters” on page 4-9 for a list of configuration parameters.
4-4
8239 Setup and User’s Guide