IBM 8239 Token-Ring Stackable Hub, Руководство по установке и эксплуатации

Страница: 42 / 141

Using a Modem
If you will be communicating with the 8239 by means of a modem connection, you
will need to install a second modem and connect it to your workstation.
Configure the terminal emulation application with:
¹
9 600 bps
¹
No parity
¹
8 data bits
¹
1 stop bit
¹
No flow control
¹
VT100 emulation
¹
The workstation’s communication port that will be used
Establishing a Session
To establish a session:
1. Invoke emulation software to establish direct connection by means of the
null-modem cable, or invoke the emulation software and dial the number of the
modem attached to the 8239.
2. After the connection is established, you will see either:
¹
The login prompt or trap messages (if the 8239 is already powered on)
¹
Diagnostic messages (if you provide power after establishing the
connection)
3. Press Enter two or three times.
4. At the login prompt, type admin and then press Enter (ADMIN is the default
user name).
5. You are now logged on.
Management Using Telnet
You can access the 8239 in-band using Telnet to an 8239 Model 1. To configure
the 8239 Model 1 for in-band connectivity, go to “Configuring the 8239 for In-Band
Connectivity” on page 4-5.
Command Interface Conventions
The main panel of the command interface for an 8239 Model 1 is shown below.
8239 Login Prompt
Login:admin
Password:mypassword
Main Menu - Accepted inputs:
1) bootp
10) replicate
2) clear 11) reset_hub
3) disable 12) restore_to_factory_default
4) display 13) retrieve
5) enable 14) save
6) help 15) set
7) load 16) script
8) logout 17) unwrap
9) ping 18) wrap
Type 'help' for information
?=Help>
4-2
8239 Setup and User’s Guide