IBM 79788BU, Руководство пользователя

Страница: 59 / 102

Remote Supervisor Adapter II SlimLine
Mounting bracket
Mounting bracket
Mounting bracket
retention latch
6. At a downward angle, slip the free end of the adapter under the tab on the
mounting bracket, aligning the holes in the adapter with the posts on the
mounting bracket and latch bracket. Rotate the rear of the adapter into the rear
mounting bracket, aligning the holes in the adapter with the posts on the
mounting bracket and latch bracket.
7. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
make sure that all tabs on both mounting brackets secure the adapter in place.
Attention: Incomplete insertion might cause damage to the server or the
adapter.
8. Replace the riser-card assembly in slot 2 on the system board. See “Replacing
a riser-card assembly” on page 33 for more information.
If you have other options to install or remove, do so now. Otherwise, go to
“Completing the installation.”
Completing the installation
To complete the installation, complete the following steps:
1. If you removed any air baffles, reinstall them now. See page 26 for baffle
location and more information.
2. If you removed the server cover, replace it and close the fan doors. For more
information, see “Replacing the server cover.”
3. Install the server in the rack cabinet. See the Rack Installation Instructions that
come with the server for instructions.
4. Connect the cables and power cords. For more information, see “Connecting
the cables” on page 46.
5. Update the server configuration. See “Updating the server configuration” on
page 47 for more information.
Replacing the server cover
To replace the server cover, complete the following steps:
v Slide the server cover toward the front of the server, fitting the cover into the tabs
for a secure fit.
v
Close the covers over the fans and snap down the two fan cover-release latches.
v Tighten the thumbscrew at the back of the server.
Chapter 2. Installing options
45