IBM 79788BU, Руководство пользователя

Страница: 45 / 102

The following notes describe the type of hard disk drives that the server supports
and other information that you must consider when installing a hard disk drive. For
a list of supported hard disk drives, see http://www.ibm.com/servers/eserver/
serverproven/compat/us/
The server supports one of the following hard disk drive configurations:
v
Servers with four hot-swap bays support 2.5-inch hot-swap SAS hard disk drives.
You can install only 2.5-inch SAS drives in these servers.
v Servers with two hot-swap bays support 3.5-inch hot-swap SAS or 3.5-inch
hot-swap SATA hard disk drives. You can install only 3.5-inch hot-swap SAS or
hot-swap SATA drives in these servers.
v
Servers with two simple-swap bays support 3.5-inch simple-swap SATA hard disk
drives. You can install only 3.5-inch simple-swap SATA drives in these servers.
v All hot-swap drives in the server should have the same throughput speed rating.
Mixing hard disk drives with different speed ratings will cause all drives to
operate at the lower throughput speed.
v
Do not mix SAS and SATA drives in the same array.
Installing a hot-swap hard disk drive
To install a 2.5-inch or 3.5-inch SAS hard disk drive, complete the following steps:
Note: If you have only one hard disk drive, you must install it in the upper-left bay.
Drive-tray assembly
Drive handle
Filler panel
SAS hard disk
drive backplane
SAS hard disk
drive backplane
Filler panel
Drive-tray assembly
Drive handle
(in open position)
Chapter 2. Installing options
31