IBM 7944, Инструкция по установке и эксплуатации

Страница: 127 / 150

Step 2. When the prompt
<F1> Setup
is displayed, press F1.
Step 3. From the Setup utility main menu, select
Boot Manager
.
Step 4. Select
Add Boot Option
➙
Embedded Hypervisor
. Press Enter, and then select Esc.
Step 5. Select
Change Boot Order
and then select
Commit Changes
; then, press Enter.
Step 6. Select
Save Settings
and then select
Exit Setup
.
Recovering the flash device image
If the embedded hypervisor flash device image becomes corrupt, you can use the
VMware Recovery
CD to
recover the flash device image.
To recover the flash device image, complete the following steps:
Step 1. Turn on the server.
Note:
Approximately 20 to 40 seconds after the server is connected to power, the power-control
button becomes active.
Step 2. Insert the VMware Recovery CD into the CD or DVD drive.
Step 3. Follow the instructions on the screen.
For additional information and instructions, see the
ESXi Embedded and vCenter Server Setup Guide
at
http://www.vmware.com/pdf/vsphere4/r40_u1/vsp_40_u1_esxi_e_vc_setup_guide.pdf .
Enabling the Broadcom Gigabit Ethernet Utility program
The Broadcom Gigabit Ethernet Utility program is part of the server firmware.
You can use it to configure the network as a startable device, and you can customize where the network
startup option appears in the startup sequence. Enable and disable the Broadcom Gigabit Ethernet Utility
program from the Setup utility.
Configuring the Gigabit Ethernet controller
The Ethernet controllers are integrated on the system board. They provide an interface for connecting to a 10
Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables simultaneous
transmission and reception of data on the network.
If the Ethernet ports in the server support auto-negotiation, the controllers detect the data-transfer rate
(10BASE-T, 100BASE-TX, or 1000BASE-T) and duplex mode (full-duplex or half-duplex) of the network and
automatically operate at that rate and mode.
You do not have to set any jumpers or configure the controllers. However, you must install a device driver to
enable the operating system to address the controllers.
To find device drivers and information about configuring the Ethernet controllers, go to
http://www.ibm.com/
supportportal/ .
Using the LSI Configuration Utility program
Use the LSI Configuration Utility program to configure and manage redundant array of independent disks
(RAID) arrays.
Be sure to use this program as described in this document.
Chapter 3
.
Configuring the server
117