IBM 7944, Инструкция по установке и эксплуатации

Страница: 101 / 150

Step 10. Reinstall the bezel screws and the video connector screws.
Step 11. Align the cable connector with the connector on the rear of the optical drive cage and press the
cable connector into the optical drive cage connector until it is firmly seated.
Step 12. Pull the cable connector latch up and hold it there while you slide the cable connector to the left;
then, slide the cable connector latch down to lock the cable in place.
Figure 73. DVD drive cable installation
Step 13. Connect the other end of the DVD cable to the connector on the system board. The following
illustration shows the cable routing for the DVD cable: The DVD cable should go on the top of the
operation information panel cable (in the middle) and the Video/USB cable (on the bottom) when all
three cables are installed in the server.
Chapter 2
.
Installing optional devices
91