Figure 5-5. 8-Bit 4mm Manual-Plug Tape Drive Type 1 Address Setting
2. Remove the SCSI bus terminators, if they are installed (see Figure 5-5).
3. Set the address on the manual-plug tape drive, before installing in the media bay, by moving switches on the switch bank. See Figure
5-5 for the 8-bit 4mm manual-plug tape drive address setting.
4. Return to the procedure that sent you here.
5. Remove the SCSI bus terminator jumpers (pins 6 and 8).
6. Use the address pin jumpers provided with the tape drive to connect the upper and lower pins that correspond to the SCSI ID you want
to use (see Figure 5-6 below).
7131-105 User's Guide
Setting the Address for a Manual-Plug 4mm Tape Drive
¦ Copyright IBM Corp. 1995, 1996
5.2.1.3 - 2
