IBM 6C1, Руководство по обслуживанию

Страница: 137 / 377

Table 3. Firmware Error Codes. (continued)
Error Code Description Action / Possible Failing FRU
20EE000A Pointer to the operating system found in
nonvolatile storage.
Values normally found in nonvolatile
storage that point to the location of an
operating system were not found. This
can happen for either of two reasons:
v
Your installed operating system
does not support storing the values.
v
Some event occurred that caused
the system to lose nonvolatile
storage information (drainage or
replacement of the battery).
If you are running AIX, this information
can be reconstructed by running the
bootlist command specifying the
device that the operating system is
installed on. Refer to your AIX
documentation for the exact syntax
and usage of the bootlist command.
To boot the operating system so that
the above-mentioned values can be
reconstructed, power off the system
and power it back on again. This
should cause the system to look for
the operating system in the devices
contained in the custom boot list or in
the default boot list, depending on the
condition of the system. If this is not
successful, use the System
Management Services menus to
modify the boot sequence (also known
as boot list) to include devices that are
known to contain a copy of the
operating system. For example, select
a hard disk known to have a copy of
the operating system as the first and
only device in the boot sequence
(boot list) and attempt to boot again.
20EE000B The system was unable to find an
operating system on the device list that
was attempted.
Go to “Boot Problems/Concerns” on
page 110.
20EE000C The system has searched the device list,
but was did not find a supported
operating system.
Go to “Boot Problems/Concerns” on
page 110.
Chapter 5. Error Code to FRU Index
119
|
|
|