IBM 6400 Series, Руководство по установке

Страница: 239 / 316

Fault Correction Procedure
239
037 STACKER JAM
TIMEOUT
CHECK STACKER
Yes A timeout message is
sent to the host if paper
is not loaded 10 minutes
after
Stop was pressed
to clear the stacker jam
fault.
Clear stacker jam and
reload paper. See
Operator’s Guide for
procedure.
038 STACKER FULL
TIMEOUT
CHECK STACKER
Yes A timeout message is
sent to the host if paper
is not loaded 10 minutes
after
Stop was pressed
to clear the stacker full
fault.
Remove paper from the
stacker.
039 STACKER FAULT
TIMEOUT
CHECK STACKER
Yes A timeout message is
sent to the host if paper
is not loaded 10 minutes
after
Stop was pressed
to clear the stacker fault.
Check for obstructions in
the stacker area. If fault
persists, contact your IBM
service representative.
041 BUFFER OVERFLOW Yes Host sends data after the
printer buffer is full.
(Serial interface.) Check printer serial port
configuration setup.
Ensure that the Data
Terminal Ready setting
matches both host and
printer settings.
042 CUSTOM SET DOES
NOT EXIST
SAVE FIRST
Yes This custom
configuration set does
not exist. Save the custom set. Refer
to “” on page 101.
043 CUSTOM SET
ALREADY EXISTS
DELETE FIRST
Yes Custom set is write–
protected. Delete existing set, then
save new set.
044 EC FIRMWARE/
HARDWARE ERROR No Fatal firmware error on
the controller board. Contact your IBM service
representative.
046 EC STOPPED AT
STATE
<state>
No Controller self–test and
initialization sequence
was halted at <state>,
where <state> is one of
10 numerically coded
messages. Contact your IBM service
representative.
Table 11: Fault Messages
Fault Message
Operator
Correctable?
Explanation Solution