IBM 5100, Руководство пользователя

Страница: 91 / 214

Chapter 6. Installing Options
77
Removing the cover (rack model)
Removing the cover (rack model)
Removing the cove r (rack model) Notes:
1. To remove or install a hot-swap hard disk drive or hot-swap power supply, it is
not necessary to remove the cover.
2. The illustrations in this document might differ slightly from your hardware.
To remove the server top cover:
1. Review the information in “Before you begin” on page 69.
2. If you are planning to install or remove any part other than a hot-swap hard disk
drive or hot-swap power supply, turn off the server and all attached devices and
disconnect all external cables and power cords.
3. Release the left and right side latches and pull the server out of the rack enclosure
until both slide rails lock.
Note: When the server is in the locked position, you can reach the cables on the
back of the server.
4. Move the cover-release lever down while sliding the top cover toward the rear of
the server about 25 mm (1 inch). Lift the cover off the server and set the cover
aside.
Attention: For proper cooling and airflow, replace the cover before turning on the
server. Operating the server for extended periods of time (over 30 minutes) with
the cover removed might damage server components.
Top cover
Left-side latch
Right-side
latch
Cover release lever