5. Connect the 2-drop power cable to the connectors located on the rear of the
4mm tape autoloader as shown in the following illustration.
Note: There are 2 female connectors and one male connector which make up
the 2-drop power cable. The 2 female connectors will be connected to the rear of
the tape autoloader, the male connector will be connected to the power
distribution cable, located in the system unit.
6. (In the system unit) Locate the SCSI Cable connector which will be used to
attach the tape autoloader; install the 50 to 68 pin Interposer to the SCSI cable.
(This will allow for a better alignment of the connector and pins, and avoid
potential pin-bending.)
7. To install the 4mm Tape Autoloader, refer to the
Installing Internal Drives section
of your system unit documentation. After completing the installation return to
Chapter 4, “Software Installation” on page 4-1 in this manual to verify the device
and device driver installation.
Chapter 3. Installing the 4MM Tape Autoloader
3-3
Содержание 4mm DDS-2 Tape Autoloader
