IBM 4247-V03, Информация по обслуживанию

Страница: 80 / 311

Table 16. Error messages (continued)
Message Description Action
034 INVALID FORMS SELECT
TIMEOUT/FORMS NAME
SELECT NEW DEVICE
(Coax interface only)
(Message and form name alternate on the
first line of the display)
014 INVALID FORMS SELECT condition
exceeded 60 seconds. Perform one of the following:
v
Restart job.
v
Cancel job.
v
Select another source and restart the
job.
v
Run the job with current source.
Refer to a 4247 User’s Guide for more
detail.
035 MARGIN ERROR TIMEOUT
ADJUST MARGIN OR LINE LENGTH
(Coax interface only)
005 MARGIN ERROR condition exceeded
60 seconds. Press Stop, then Start. Left margin value
will be reset to 10 for current line only.
036 TEAR PAPER TIMEOUT
TEAR OFF AT INPUT AND PRESS EJECT
(Coax interface only)
092 FANFOLD EJECT condition exceeded
60 seconds. Tear off paper before entering the printer
and press Eject to allow operation to
complete.
050 MACHINE CHECK ERR XXX Firmware error in supervisor code. Turn off and then turn on the printer. If
message remains, install a new Logic
Board (see Logic board).
051 MACHINE CHECK ERR XXX Firmware error in interpreter code. Turn off and then turn on the printer. If
message remains, install a new Logic
Board (see Logic board).
052 MACHINE CHECK ERR XXX Firmware error in print manager code. Turn off and then turn on the printer. If
message remains, install a new Logic
Board (see Logic board).
053 MACHINE CHECK ERR 2XX
053 MACHINE CHECK ERR 42X
Firmware error in engine code. Turn off and then turn on the printer. If
message remains, install a new Logic
Board (see Logic board).
Chapter 1. Diagnosing problems
80