IBM 4247-V03, Информация по обслуживанию

Страница: 127 / 311

T&D error messages and actions
Table 20. T&D error messages and actions
Error Message Description Action
ERROR RAM
TEST RAM error Replace the logic board (see Logic board).
ATTACHMENT
CARD IS NOT
COMPATIBLE
WITH PRINTER
BASE CODE Coax card error Verify that the coax card is installed with the coax base
code.
WAITING CODE
DOWNLOAD
USING PARALLEL
PORT Operator error Verify that you are using the Stop and Test keys at
power on to initiate test and diagnostics
TD 1 FRU 5 X
- or -
TD 1 FRU 4
X
Microcode/Hardware
Match Error Replace the logic board (see Logic board.
TD 1 FRU 2 2 Microcode error Replace the logic board (see Logic board.
TD 2 FRU 1 X Operator panel
failure 1. This error can occur if a key is not pressed in less
than 10 seconds. Run T&D02 again to verify the
problem.
2. Replace the operator panel (see Operator panel.
3. Replace the logic board (see Logic board).
4. Replace the operator panel cable.
TD 3 FRU 0 X (*) Parallel interface
failure Replace the logic board (see Logic board).
TD 4 FRU 0 X Microcode error Replace the logic board (see Logic board).
TD 08 FRU 0 X AFTA failure 1. See Standard AFTA service check and adjustment.
2. Replace the logic board (see Logic board).
Chapter 2. Diagnostics
127