IBM 4247-V03, Информация по обслуживанию

Страница: 110 / 311

Verifying AFTA calibration using T&D08: To verify the calibration:
1. Set the operator menu to
AFTA=0
.
2. Load the paper into the print area. Note the wheel position.
3. Park the paper.
4. Set the operator menu to
FIXED=1
.
5. Load the paper into the print area. Note the wheel position.
6. The wheel position should be the same for
AFTA=0
and
FIXED=1
within ±0.25.
7. The wheel should be pointing to the middle of sector 1.
8. Verify printer operation by printing T&D12 on single-part forms, using a good ribbon. The print should appear
dark.
Press the Micro
↓
key to bypass this message.
T&D09—First printing line adjustment test
This test allows you to adjust the first print-line for the rear (base) forms path and the front (second or optional)
forms path (if it is installed) from the operator panel (see Paper path nomenclature).
The value set by this test becomes the first print-line position when the configuration menu item
Paper Load
Position
is set to
0
.
Note: If you adjust this value you also must run T&D11
1. Display:
T&D09 First Printing Line Adjustment Test RUN TEST ? YES END NO
2. Press the Line Feed key.
T&D09 First Printing Line Adjustment Test FANFOLD REAR ADJ YES NO
Chapter 2. Diagnostics
110