IBM 17352GX, Инструкция по установке и эксплуатации

Страница: 95 / 136

Chapter 4: Using the OSCAR interface 79
Figure 4.18: Scan window
3. The window contains a listing of all target devices that are attached to the appliance. To select
target devices to be scanned, complete one of the following steps:
• Select the check box next to the target devices that you want to scan.
• Double-click on a target device name or port.
• Press Alt and the eID number of the target device that you want to scan. You can select up
to 16 target devices from the list.
4. In the Time field, type the number of seconds (from 3 to 255) of time before the scan moves to
the next target device in the sequence.
5. Click OK .
To remove a target device from the scan list, complete the following steps:
1. To select a target device to be removed from the scan list, complete one of the following steps:
• In the Scan window, clear the check box next to the target device to be removed.
• Double-click on the target device name or port.
• Press Shift + Delete to remove the selected target device and all entries below it.
• Click the Clear button to remove all target devices from the scan list.
2. Click OK .
To start the Scan mode, complete the following steps:
1. Start the OSCAR interface.
2. Click Commands . The Commands window opens.
3. Select Scan Enable in the Commands window. Scanning will begin immediately.
4. Click X to close the Commands window.