IBM 160 GB DLTV4, Инструкция по установке и эксплуатации

Страница: 17 / 56

Chapter 3. Using the tape drive
The following illustration shows the front panel of the tape drive.
Cartridge door
Unload button
Media LED
Clean LED
Fault LED
Power LED
The following table describes the Power LED on the tape drive front panel.
Table 1. Power LED description
State Description
Off There is no power to the tape drive
On The tape drive power is on, and either there is no tape cartridge
installed, or the tape is not moving.
Flashing A tape cartridge is loading, or the tape is in motion.
The following table describes the fault, clean, and media LEDs.
Table 2. LED descriptions
Fault Clean Media Description
— Off Flashing
slow
One of the following:
v The format of the tape cartridge is unsupported.
v
The type of tape cartridge is unsupported.
v The tape cartridge is damaged.
— — Lit A DLT1 (DLT VS 80) formatted DLTtape IV tape
cartridge is loaded.
— Flashing
slow
Off An error has occurred. Clean the tape drive and retry
the operation. If the problem continues, replace the tape
cartridge and retry the operation. If the problem
continues, replace the tape drive. See “Removing a tape
drive” on page 15 for more information.
— Lit Off Clean the tape drive and retry the operation. If the
problem continues, replace the tape cartridge and retry
the operation. If the problem continues, replace the tape
drive. See “Removing a tape drive” on page 15 for more
information.
— Flashing
fast
Off Cleaning is in progress.
© Copyright IBM Corp. 2006
9