IBM 160 GB DLTV4, Инструкция по установке и эксплуатации

Страница: 13 / 56

Note: The illustrations in this document might differ slightly from your hardware.
2. Attach the mounting rails to the tape drive (if applicable).
3. Align the screw holes in the bay with the threaded holes in the tape drive
housing.
Attention: Use only the screws that come with the tape drive. Other screws
might be too long and might damage the tape drive.
When you mount the tape drive, follow these guidelines:
v
Make sure that no objects such as screw heads, cables, or adjacent devices
are pressing against the frame.
v Make sure that nothing blocks the ventilation slots on the bottom and rear of
the tape drive.
4. Insert a screw through each of the screw holes in the bay into the threaded
holes in the tape drive, and tighten the screws with a screwdriver.
Connecting the cables
To connect the cables to the tape drive, complete the following steps:
Chapter 2. Installing the tape drive
5