- 30 -
D2) FORWARD BELT
- Make sure the forward cable
’s setting screw, located on the handlebar (Fig 5 Ref B) is set
at zero and so is fully screwed down.
- Remove the setting screw on the brake (Fig 6 Ref C) by unscrewing the screw (Fig 6 Ref
G)
- Extract the rotor engagement belt (Fig. 12 Ref A) by turning the engine pulley
anticlockwise.
- Extract the forward belt (Fig. 11 Ref A) removing it from the same side as the large pulley
(Fig. 11 Ref B) and turning the engine pulley anti-clockwise (Fig. 11 Ref C).
- Fit a new belt by inserting it first in the engine pulley (Fig. 11 Ref C) then in the other (Fig.
11 Ref B).
- Check the distance between the two parts is 50 mm by pressing down on the bottom of
the belt (Fig. 11 Ref G) with your finger.
- If the distance is not as shown,
you may contact an authorised service centre.
They will follow the procedures outlined below :
a)move the engine by loosening the locknuts until the distance is correct.
b)after adjusting the position of the engine and before tightening the locknuts to secure it,
check the two pulleys (Fig. 11 Ref B and C) are aligned.
- Act on the forward engagement lever (Fig 5 Ref A) and make sure that the height of the
spring during work is 20 mm (Fig 11 Ref E) when the belt tightener is at the end of its run
(Fig. 11 Ref D).
- If the height of the spring is not correct when the tightener is engaged, adjust the clamp
securing the cable (Fig 11 Ref F) accordingly.
- The compression height of the spring can also be adjusted using the setting screw of the
forward cable (Fig 5 Ref B).
Figure 11
Содержание IB 642 HD
