I-Tech PHYSIO 4, Руководство пользователя

Страница: 29 / 88

IACER Srl 25 MNPG178
Before starting the ionophoresis session, clean the skin near the area to be
treated; connect the jacks of the electrostimulation cable to the black
rubber electrodes with cable disconnected from I-TECH PHYSIO.
Moisten the two sponge electrodes abundantly.
ATTENTION
: wring the sponge electrodes to avoid dripping, then
put the drug on an electrode as follows:
• drugs with positive polarity: dissolve this type of drug on
the electrode connected to the positive pole (red
connection, cathode).
• drugs with negative polarity: dissolve this type of drug on
the electrode connected to the negative pole (black
connection, anode).
• Bipolar drugs: these can be dissolved on either the
positive pole or the negative pole.
At this point, insert the two black rubber electrodes,
previously connected to the electrostimulation cable
inside the sponge coverings (one with the drug and the
other without). Position the electrode with the drug on
the painful area, and the other electrode on the other
side ( Figure 3 ) with the help of the elastic band
supplied with the kit. Connect both cables at the
appropriate jack (channel 1 or channel 2, choose both
channels only if you want to stimulate two different
areas) and turn I-TECH PHYSIO 4/EMG on. If you wish to
double the number of electrodes, you can request an
additional ionophoresis kit by contacting directly the
Manufacturer.
It is possible to find a slight reddening of the skin at
the end of the program; the redness normally
disappears a few minutes after the end of the
program.
ATTENTION . Do not use the iontophoresis program in proximity of
metal prostheses.
Ionophoresis is also used for the treatment of diseases affecting the
urogenital male apparatus, like IPP (Induratio Penis Plastica) or La Peyronie
disease.
It is recommended to consult your specialist or treating physician before
starting treatment.
Figure 3 – Positioning of
electrodes placed at the
ends of the muscle to be
stimulated.