I-PEX ISH Series, Инструкция по эксплуатации

Страница: 19 / 29

ISH & ISHV & ISHVS CONNECTOR Instruction Manual
Document No.
HDM-0002
19 / 29
Confidential C
6. How to release secondary lock
6-1. Secondary lock part
①
Place the releasing jig into the secondary lock part taper situated at the bottom of the female housing, and move the
jig to the direction shown in Fig. 36 to release the secondary lock part (release one side at a time).
Secondary lock part releasing jig: Part No. AP-0004-08-002
Refer to Table 6 for the Part No. that use the secondary lock part releasing jig.
Notes
①
Do not insert the releasing jig into any other incorrect place.
②
Check for any deformation or damage on both of the secondary lock part and the female housing after releasing the secondary lock part,
before continuing any operation.
③
If there is any damage or deformation, do not use the damaged item. Replace the item with a new one.
④
Only use the secondary lock part releasing jig specified.
⑤
Care must be taken when handling the secondary lock part releasing jig (it has very sharp edge)
⑥
Care must be taken not to damage edge of the jig (e.g. from dropping, etc.)
Fig 36. How to release the secondary lock part
Place flat surface inside
Direction of release
Releasing jig aperture
Secondary lock part releasing jig