I-PEX ISH Series, Инструкция по эксплуатации

Страница: 23 / 29

ISH & ISHV & ISHVS CONNECTOR Instruction Manual
Document No.
HDM-0002
23 / 29
Confidential C
8.Rear cover installation (Only housing correspond to rear cover)(Rear cover : Individual part)
①
Verify that pin numbers of the female housing and the rear cover are the same and also the female housing corresponds to
rear cover. In addition, check that there is no damage, deform or dirt present.
※
There are two lock portions at right and left side respectively.
②
Check the directions of the female housing and the rear cover are correct.
③
Push the rear cover to female housing horizontally until the rear cover makes an audible click.
※
It is possible to install at 40N to 50N.
※
It is possible to install the rear cover to the female housing which is either inserted or not inserted the terminals. When handling the terminal
inserted female housing, it should be careful not to catch the wire between the female housing and the rear cover.
④
Cannot remove the rear cover after installed one time.
※
Forcibly remove the female housing and the rear cover, it may result in damage.
※
Do not reuse the forcibly removed female housing and rear cover.
Fig 46. Corresponding Female housing for Rear cover Fig 47. No corresponding Female housing for Rear cover
Fig 48.
Direction of installation
Fig 49. Installation of Rear cover
Direction of installation
Engaging portion
Engaging portion
Table 6. REAR COVER
＆
FEMALE HOUSING
8 ISH CONNECTOR 8P V0020-91008-216 V0020-94008-611
V0016-91012-215
V0016-91012-216
V0016-91012-217
V0016-93012-211
16 ISH CONNECTOR 16P V0016-91016-212 V0016-94016-611
20 ISH CONNECTOR 20P V0016-91020-211 V0016-91020-211
ISH CONNECTOR 12P V0016-94012-611 12
No. of
Poles
NAME
FEMALE HOUSING
PART NO.
REAR COVER
PART NO.