Hyundai 20G-7, Руководство по обслуживанию

Страница: 367 / 420

TIMING BELT
2-84
6) Install the timing belt not to loosen in the following order.
Crankshaft sprocket(A) Idler pulley(B) Camshaft
sprocket(C) Timing belt tensioner(D).
(After installing timing belt, auto tensioner may be
installed)
7) Be sure that timing mark on each sprocket is placed on
the proper position.
8) Remove the tensioner arm fixing pin.
9) Insert a hexagonal wrench to the adjuster groove as
below, rotate it counterclockwise to place the arm indi-
cator in the middle of base groove.
CAUTION
Do not rotate the wrench clockwise, or the auto
tensioner is not normally functioned.
L4GC144A
10) With the arm indicator fixed not to move, tighten the
tensioner fixing bolt.
L4GC023A
A
B
C
D
Tightening torque 2.3 ~ 2.9kgf · m
11) Rotate the crankshaft to 2 turns clockwise and then be
sure that the auto tensioner arm indicator is placed in
the middle of base groove.
12) If the arm indicator is out of the middle of groove, loosen
the bolt and repeat the above procedure.
13) Install the timing belt lower cover.
Tightening torque 0.8 ~ 1.0kgf
·
m
A
B
L4GC145A