Hyundai 20G-7, Руководство по обслуживанию

Страница: 218 / 420

6-30
PUMP 23
Gently slide the gear housing over the rear
bearing block assembly, slide housing
down until the housing engages the dowel
pins. Press firmly in place with hands, do
not force or use any tool.
Check to make sure the intake port in the
housing in on the same side as the open
end of the E-seal and that the marked
lines on the mounting flange and gear
housing are in alignment.
The surface of the rear bearing block
should be slightly below the face of the
gear housing. If the bearing block sits
higher then the rear face of the gear
housing then the E-seal or O-ring have
shifted out of the groove. If this is the
case, remove the gear housing and check
for proper seal installation.
(13)
(14)
PUMP 24
Install the two remaining dowel pins in the
rear of the gear housing and place the
end cover over the back of the pump. (15)
PUMP 25
Install the four spacers and hexagon head
bolts through the bolt holes in the end
cover, hand tighten. (16)