Hyster D264, Руководство по обслуживанию и ремонту

Страница: 29 / 30

WARNING
Making repairs with the battery connected can
cause a short circuit. Disconnect the battery by
separating the connectors before opening the
electrical compartment covers or inspecting/
repairing the electrical system. High current flow
during a short circuit can cause injury or parts
damage.
2.
Disconnect the battery power cable connector
from the truck connector located on the right
side of the frame. Pull the battery cable connec-
tor handle to separate the battery connector
from the truck connector.
3.
Remove the plastic cover from the operator
compartment.
4.
Discharge the capacitors. See Discharging the
Internal Capacitors.
5.
Tag and remove IFB wire connections. Remove
the IFB from the mounting posts on the truck
frame.
6.
Install the electrical wiring to the IFB as re-
moved.
CAUTION
Over tightening the attaching hardware can dam-
age the IFB.
7.
Position the IFB onto the mounting posts and
secure as removed.
8.
Install the plastic cover(s) to the operator com-
partment as removed.
9.
Engage the battery cable connectors. Install the
key and turn the key switch to the ON position.
Test for proper operation. Remove the blocks
from the drive wheels and the DO NOT OP-
ERATE tag.
Most fuses are located in the electrical compart-
ment. Remove cover over electrical compartment
for access. The condition of some fuses can be
checked by looking at them. Other fuses do not
change in looks and must be checked with an ohm-
meter to determine continuity. Disconnect battery
and remove a fuse before checking the fuse.
NOTE:
Some fuses for accessories may be located
in a separate fuse holder such as the heater option
fuses. Trucks with camera options also have fuses
located in the camera power module located on the
front carriage.
Table 3. IFB Fuses
FUSES CIRCUIT RATING
FU10 Key Switch, E-
Stop, Start
10A
FU11 Battery,
Contact Coil,
Heater
(Optional)
10A
JP1 (24V boards
only)
7.5A
FU12 Logic Power 10A
FU13 Spare 10A
1. FU10
2. FU11
3. JP1
4. FU12
5. FU13
6. D6 DIODE (JP-2)
Figure 13. Fuse & Diode Locations
2200 SRM 1612 Integrated Fuse Board (IFB)
21