Hyster D264, Руководство по обслуживанию и ремонту

Страница: 14 / 30

1.
Move the lift truck to a safe, level area, and
completely lower the mast. Turn the key switch
to the OFF position and remove the key. Attach
a DO NOT OPERATE tag to the control han-
dle and block the drive wheels to prevent unex-
pected movement.
2.
Disconnect the battery power cable connector
from the truck connector located on the right
side of the frame. Pull the battery cable connec-
tor handle to separate the battery connector
from the truck connector.
3.
Discharge the capacitors. See Discharging the
Internal Capacitors.
4.
Access the key switch wiring:
a.
Remove the plastic cover from the operator
compartment on fore/aft stance models.
OR
b.
Remove the plastic cover from the bottom of
the arm rest console on sidestance models.
See Figure 20.
NOTE:
Make note of the position of the key switch
before removal.
5.
Remove the nut retaining the key switch to the
mounting bracket and remove the key switch
with the wiring attached.
6.
Tag and disconnect the electrical wiring from
the key switch. See Figure 7.
7.
Install the electrical wiring to the new key
switch as removed.
8.
Position the switch into the mounting hole as
removed.
9.
Install the jam nut onto the key switch as re-
moved.
10.
Install the plastic cover(s) to the operator com-
partment as removed.
11.
Engage the battery cable connectors. Install the
key and turn the key switch to the ON position.
Test for proper operation.
12.
Remove the blocks from the drive wheels and
the DO NOT OPERATE tag from the control
handle.
Figure 7. Electrical Connections
Key Switch 2200 SRM 1612
6