Hypertherm powermax1650, Руководство оператора

Страница: 16 / 106

1-2
Hypertherm
11/08
SAFETY
RECOGNIZE SAFETY INFORMATION
The symbols shown in this section are used to
identify potential hazards. When you see a
safety symbol in this manual or on your machine,
understand the potential for personal injury, and follow
the related instructions to avoid the hazard.
FOLLOW SAFETY
INSTRUCTIONS
Read carefully all safety messages in this
manual and safety labels on your machine.
• Keep the safety labels on your machine in good
condition. Replace missing or damaged labels
immediately.
• Learn how to operate the machine and how to use
the controls properly. Do not let anyone operate it
without instruction.
• Keep your machine in proper working condition.
Unauthorized modifications to the machine may
affect safety and machine service life.
DANGER WARNING CAUTION
Hypertherm uses American National Standards
Institute guidelines for safety signal words and
symbols. A signal word DANGER or WARNING is
used with a safety symbol. DANGER identifies the
most serious hazards.
• DANGER and WARNING safety labels are
located on your machine near specific hazards.
• DANGER safety messages precede related
instructions in the manual that will result in serious
injury or death if not followed correctly.
• WARNING safety messages precede related
instructions in this manual that may result in injury
or death if not followed correctly.
• CAUTION safety messages precede related
instructions in this manual that may result in
minor injury or damage to equipment if not
followed correctly.
Fire Prevention
• Be sure the area is safe before doing any cutting.
Keep a fire extinguisher nearby.
• Remove all flammables within 35 feet (10 m) of
the cutting area.
• Quench hot metal or allow it to cool before
handling or before letting it touch combustible
materials.
• Never cut containers with potentially flammable
materials inside – they must be emptied and
properly cleaned first.
• Ventilate potentially flammable atmospheres
before cutting.
• When cutting with oxygen as the plasma gas,
an exhaust ventilation system is required.
Explosion Prevention
• Do not use the plasma system if explosive dust
or vapors may be present.
• Do not cut pressurized cylinders, pipes, or any
closed container.
• Do not cut containers that have held combustible
materials.
CUTTING CAN CAUSE FIRE OR EXPLOSION
WARNING
Explosion Hazard
Argon-Hydrogen and Methane
Hydrogen and methane are flammable gases that
present an explosion hazard. Keep flames away from
cylinders and hoses that contain methane or hydrogen
mixtures. Keep flames and sparks away from the torch
when using methane or argon-hydrogen plasma.
WARNING
Hydrogen Detonation with
Aluminum Cutting
• When cutting aluminum underwater, or with the
water touching the underside of the aluminum,
free hydrogen gas may collect under the workpiece
and detonate during plasma cutting operations.
• Install an aeration manifold on the floor of the water
table to eliminate the possibility of hydrogen
detonation. Refer to the Appendix section of this
manual for aeration manifold details.