ArcGlide THC Replacement Parts
Field Service Bulletin 806560
33
2 – Replacing ArcGlide parts
To remove the breakaway flex track:
1.
Insert a screwdriver through the access hole in the lifter mounting plate and remove
the screw from the flex track anchor. You may need to move the breakaway cable
down to access this screw.
2.
Lift the breakaway cable from the flex track anchor at the top of the slide and remove
the screw in the anchor.
3.
Cut the cable ties that secure the breakaway cable in the motor enclosure and
disconnect the connector from J4 on the lifter interface board.
4.
Remove the cable from the slide and motor enclosures.
To remove the breakaway cable from the flex track:
1.
Remove the final segment on the end with the cable connector that you removed
from the lifter interface board and set it aside for reuse.
2.
Slip the individual wires between the cable jacket and the PCB connector through
the slot in each segment of the track as you pull down on the cable until the cable is
free of the track.
To replace the breakaway cable in the flex track:
1.
Slip the individual wires between the cable jacket and the PCB connector through the slot in each segment of the
track as you pull it to the top of the track.
2.
Replace the final segment of the track under the PCB connector.
Verify that the alignment pin on this final segment is on the same side of the flex track as
the slots in the segments of the track.
To replace the breakaway flex track:
1.
Insert the alignment pin in the flex track anchor next to the top of the slide
and replace the screw that secures the anchor. Tighten the screw to 0.33
N·m (3 lb·in.).
2.
Thread the cable connector through the hole in the bottom of the motor
enclosure and install the connector in J4 in the lifter interface board.
3.
On the end of the flex track with the breakaway sensor switch, insert the
alignment pin in the anchor on the back of the lifter mounting plate. Fasten
the screw through the access hole in the lifter mounting plate and into the
flex track anchor.
Tighten the screw to 0.33 N·m (3 lb·in.).
4.
Verify that the switch cable fits through both end segments of the flex track
and around the lifter mounting block below the motor enclosure.
Breakaway cable
and flex track
Flex track anchor
Torch mounting
plate
Breakaway
sensor switch
cable
Lifter mounting
block
Flex track
anchor
