Hypertherm ArcGlide THC, Информационный бюллетень по обслуживанию поля

Страница: 27 / 40

ArcGlide THC Replacement Parts Field Service Bulletin 806560 27
2 – Replacing ArcGlide parts
228589 – LCD display
The LCD display is used in both the control module and
the HMI.
To remove the LCD display in the control module, follow
the steps in
Accessing control module parts on page 12
to open the rear panel of the control module. Set aside all
screws and other hardware for reuse.
To access the LCD display, you must use the following
procedures to remove additional parts:
 428081 – Servo amplifier module on page 36
 228578 – THC processor board on page 15
 228577 – THC control interface board on page 14
Follow the instructions on page 28 to replace the LCD display in an HMI.
To remove the LCD display in a control module:
1.
Remove the ribbon cable from the LCD display board.
2.
Cut the cable tie that attaches the red and black wires to the LCD display.
3.
Remove the 4 screws from the standoffs at the corners of the display board.
4.
Lift the board off the standoffs.
To replace the LCD display in a control module:
1.
Fit the new LCD display board over the standoffs with the black connector next to the green ribbon cable.
2.
Fasten the 4 screws in the standoffs. Tighten the screws to 1.13 N·m (10 lb·in.).
3.
Use cable ties to secure the red and black wires to the cable tie anchor on the front of the enclosure.
4.
Connect the 16-pin ribbon cable to the black connector on the board.
Use the following procedures to replace additional parts:
 228577 – THC control interface board on page 14
 228578 – THC processor board on page 15
 428081 – Servo amplifier module on page 36