22
ArcGlide THC Replacement Parts
Field Service Bulletin 806560
2 – Replacing ArcGlide parts
228585 – Enable/disable switch
Follow the steps in
on page 12 to open the front cover of the motor
enclosure. Set aside all screws and other hardware for reuse.
To remove the enable/disable switch:
1.
Remove the hex boot around the enable/disable switch on the front cover of the
motor enclosure and set it aside.
2.
Pull the switch through the back of the front cover.
3.
Remove the hex nut and washer from the back of the switch. Set the washer aside.
To replace the torch enable/disable switch:
1.
Remove the hex nut from the back of the new switch.
2.
Install the washer on the back of the switch.
3.
Replace the hex nut and finger-tighten it plus a 1/4 turn.
4.
Align the key in the switch opening with the slot on the switch and push the switch into place.
5.
Finger-tighten the hex boot around the switch on the front cover.
6.
Replace the front cover of the motor enclosure and fasten the 4 screws. Tighten the screws to 1.13 N·m (10 lb·in.).
