Hyperion EOS 0840i, Руководство пользователя

Страница: 6 / 34

SPECIAL FEATURES
Cycle Charge/Discharge Mode
The user may program the charge to cycle the battery up to 5 time. Cycle mode is the
automatic process of continuously charging and discharging your battery to simulate use. This
is useful for “breaking-in” your pack or judging the batteries capacity.
“Re-Peak” Mode for NiMH/NiCd Battery
In “Re-peak” charge mode the charger will recharge your pack upto three times in a row
automatically. This is to making certain that your NiCd/NiMh battery is fully charged.
Delta-peak Sensitivity for NiMH/NiCd
When the batteries voltage exceeds the preset voltage threshold the charger will stop charging
automatically.
Automatic Charging Current Limit
You may program the maximum allowed charge current. This is useful for the NiCd or NiMH
batteries that have low impedance and capacity.
Capacity Limit
This user-defined setting safety feature calculates the maximum allows charged capacity of the
pack. If the capacity limit exceeds this predefined capacity then your charging will stop.
Temperature Threshold*
In the case that your battery over heats during the charging process then the temperate sensor
will sense this temperature and will terminate charging.
*Temperature sensor sold seperate.
Processing Time Limit:
The user may define the maximum allowed time to charge, if the charger surpasses this
specified time then the charger will terminate.
LiPo Battery Meter
This useful feature give the user the ability to analyze the batteries total voltage and individual
cells voltage.
· 04 Hyperion EOS 0840i
“Fast” Charge Mode For Lithium Batteries
“Fast” charge mode quickens the duration of charging by only filling the battery to approx 90%
of full capacity. Typically the last 10% of charging takes the longest time due to the fact that the
charger must reduce charge rate so the cells do not overcharge when they reach peak voltage.
Battery Internal Resistance Meter
The user may check each cell's individual internal resistance. This reading is in milli-ohm units.
“Store” mode is used to control the final voltage of your battery so that you may safely store
them. If you leave your batteries fully-charged and do not intend use them soon then it is
dangerous and will cause damage to your cells.
“Store” Mode