Hyperion EOS 0840i, Руководство пользователя

Страница: 12 / 34

OPERATING PROGRAM
Here is a detailed example on how to use the charger. This example is for Li-Po
BALANCE CHARGE:
1. Connection
Connecting to your power source 1).
· 10 Hyperion EOS 0840i
There are two kinds of power source available when powering on your charger for the
first time, please choose DC Power Supply or Lead Acid Battery accordingly. The
maximum amperage and Cutoff voltage also needs to be specified based on your setup
Power Supply?
>DC Power Supply
DEC INC
Power Source
>Battery
Bat.Supply:30.0A
Cut Volt.: 11.0V
DC Supply: 30.0A
Cut Volt.: 11.0V
ENTER
ENTER
DC Supply: 30.0A
Cut Volt.: 11.0V
ENTER
DEC INC
Bat.Supply:30.0A
Cut Volt.: 11.0V
ENTER
DEC INC
Press the ENTER/START button to make the current value blink then change the
value by pressing DEC and INC button. The value will be stored by re-pressing the
START/ENTER button. At the same time cut voltage will start to blink, press DEC
and INC button to change the value and repress START/ENTER button to store it.
4mm Bullet Connectors
plugging to Hyperion DC
power supply directly
The EOS 0840i comes with male 4mm Bullet connectors attached to the power
INPUT cables. These cables are appropriate for attaching directly to most high-
quality AC-DC power supply units, such as the Hyperion DC Power supply.
Make sure to choose the right power source and set up the right current
and cut voltage.
The charger will save the setting for next use if you don’t change it. So if
you change the power source, please make sure to change the setting in
the charger.
Note1:
Note2:
Connecting to DC power supply