HYOSUNG COMET 650 FI, Руководство пользователя

Страница: 50 / 90

49
1. Inspect every day once before riding
the motorcycle.
2. The transmission is in neutral.
3. The ignition switch is in the “ON”
position.
4. The engine stop switch is in the “ ”
position.
5. Moving the side stand to the fully
upper position.
6. Pull in the clutch lever.
RIDING TIPS
STARTING THE ENGINE
Before attempting to
start the engine make
sure:
The are equipped
with the side stand ignition interlock
system.
If the transmission is in neutral or side
stand up, you can only start the engine
with pulling in the clutch lever.
This side stand ignition interlock system
prevents the motorcycle from being
started with side stand down.
Make sure that the side stand igintion
interlock system is working properly
before riding.
WARNING
These motorcycles always come on the
head lamp, position lamp, meter lamp,
tail lamp and license plate lamp when
starting the engine.
CAUTION
Running the engine indoors or in a
garage can be hazardous.
Exhaust gas contains carbon monoxide,
a gas that is colorless and odorless and
can cause death or severe injury.
Only run the engine outdoors where
there is a fresh air.
WARNING
Running the engine too long without rid-
ing may cause the engine to overheat.
Overheating can result in damage to
internal engine components and discol-
oration of exhaust pipes.
Shut the engine off if you cannot begin
your ride promptly.
CAUTION
●
Take off the starter switch right after
started.
●
Do not engage the starting motor for
more than five seconds at a time as it
may overheat the wiring harness and
starting motor.
If the engine does not start after sev-
eral attempts, check the fuel supply
and igintion system.
(Refer for Page 77)
CAUTION
Comet650 2008.7.11 3:40 PM ˘ ` 49 JINSUN 300DPI 100LPI T