Installation of Ball Valve Assembly
The ball valve and quick connect adapter must be installed on the RO storage tank.
a. Install the 1/4" x 3/8" male connector onto the ball valve. Tighten the fitting very gently until it is snug.
Be very careful
not to over-tighten or the threads may strip.
b. Tighten the ball valve assembly onto the RO storage tank. Tighten the fitting very gently until it is snug.
Be very careful
not to over-tighten or the threads may strip.
Drilling Sink Hole
The typical 1-1/8" sink hole will accommodate the standard spigot. Once the location of the spigot has been determined,
always check below the point you are about to drill to ensure it is unobstructed and that it isn't over a reinforcing rib.
a. Center punch the desired location to provide a starting point for your drill.
b. Drill a 1/8" pilot hole.
c. Enlarge the pilot hole using a 9/16" drill bit for standard faucet.
d. Remove all burrs and sharp edges.
e. Immediately clean up the sink area.
NOTE: If an enamel or porcelain sink is encountered, it is very important that the layer of porcelain be removed before
following the steps outlined above. This can be accomplished by gently grinding away, using a hobby grinder and silicon
carbide wheel, enough area of porcelain down to the metal base to accommodate a 1-1/8" high speed steel hole saw. The
hole saw cannot contact surrounding porcelain or chipping can occur. Now the steps outlined above can be followed.
Installation of Non-Air Gap Faucet
1. Place the chrome washer and the rubber washer on the base of the faucet.
2. Apply 5-7 wraps of the teflon tape to the bottom of the brass stem. Install 3/8" quick connect faucet adapter provided.
Tighten gently until fitting is snug. Be careful not to over-tighten as the threads may strip.
3. Mount the faucet and complete assembly.
Ball Valve
Tank
3/8 Tubing
Adapter
Figure 6 - Pressure Tank Shutoff Valve
5
Figure 5 -
Recommended
Drain Saddle
Connections
Vertical Placement
Horizontal Placement
Never Place Here
Garbage Disposal
